3D printed in PETG on the Bambu X2D.
Updates September 2026: Printed a set of brackets (yellow) that glued onto the top and bottom part of the filter holder assembly, held in place with a bolt(orange). This is to prevent the top part (grey) from being accidentally knocked off and having the filter fall out. Note the cut in channels/reservoirs for the two-part epoxy glue.
Testing the new clamps. Note the brass inserts.
DIY 3D printed 100mm*100mm*2mm filter holder for the Olympus 7-14mm f2.8 lens.
With polarizing filter = no glare.More 3D printed accessories for telescopes and cameras.
